New replacement Myford Super 7 & ML7-R motor - 3/4hp 240v.

Fitting the correct resilient mounted motor is very important as it is an essential component contributing to the smooth/vibration free running of the Myford lathe, many of the original resilient framed motors fitted to these lathes have over time been incorrectly replaced with standard 'foot mounted' motors which can spoil the action and accuracy of the lathe by causing excessive vibration and noise.

Included is a wiring diagram showing you various wiring configurations to wire through your existing Myford Dewhurst reversing switch.

Early manufactured Super 7s were fitted with a smaller 1/2hp motor but later models were fitted with a 3/4 hp motor as standard, so if you have an early lathe that needs a new motor we recommend upgrading to this 3/4 hp motor.

  • 3/4 Hp
  • 240-volt single phase
  • 1425 Rpm
  • Full load amps 5.6
  • Shaft diameter 5/8"
  • Keyway 3/16"
  • Drip proof enclosure
  • Capacitor start.
There are no reviews for this product.

Write a review

Note: HTML is not translated!
    Bad           Good

Myford Super 7 Motor - Resilient Mounted

  • £205.00

Related Products