New replacement resilient mounted motor for the Myford ML7 and ML10 lathe, this is a direct replacement for the original motor (which are no longer produced)
Included is a wiring diagram showing you various wiring configurations to wire through your existing Myford Dewhurst reversing switch.
Early manufactured ML7s were fitted with a smaller 1/3hp motor but later models were fitted with a 1/2hp motor as standard, so if you have an early lathe that needs a new motor we recommend upgrading to this 1/2hp motor.
- 1/2 Hp
- 240-volt single phase
- 1425 Rpm
- Full load amps 4.0
- Shaft diameter 5/8"
- Keyway 3/16"
- Drip proof enclosure
- Capacitor start.
Myford ML7 & ML10 Motor - Resilient Mounted
- Choose By Manufacturer Myford Lathe Spares
- Availability: Pre-Order