New replacement resilient mounted motor for the Myford ML7 and ML10 lathe, this is a direct replacement for the original motor (which are no longer produced)

Included is a wiring diagram showing you various wiring configurations to wire through your existing Myford Dewhurst reversing switch.

Early manufactured ML7s were fitted with a smaller 1/3hp motor but later models were fitted with a 1/2hp motor as standard, so if you have an early lathe that needs a new motor we recommend upgrading to this 1/2hp motor.

  • 1/2 Hp
  • 240-volt single phase
  • 1425 Rpm
  • Full load amps 4.0
  • Shaft diameter 5/8"
  • Keyway 3/16"
  • Drip proof enclosure
  • Capacitor start.
There are no reviews for this product.

Write a review

Note: HTML is not translated!
    Bad           Good

Myford ML7 & ML10 Motor - Resilient Mounted

  • £178.00

Related Products